Cisco CTS-SX10-K9 Manuale introduttivo - Pagina 15

Sfoglia online o scarica il pdf Manuale introduttivo per Sistema di conferenze Cisco CTS-SX10-K9. Cisco CTS-SX10-K9 25. Telepresence sx10 quick set

Stampa la pagina
Cisco TelePresence SX10 Quick Set
SX10 Quick Set

Setting the date, time and location

(When not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among
other things this information is used to time stamp messages
transmitted to gatekeepers and other network elements.
The time and date is shown in the top right corner of the main
display.
If you are changing a value setting,
you have to always click
save
to confirm the change.
Back to task overview
D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.
Contents
Introduction
1. Go to the
Configuration
Configuration.
Open the
Time
2. Select your preferred date format in the
down list.
3. Select your preferred time format in the
down list.
4. Select your time zone in the
5. Open the
NetworkServices
6. Under the
NTP
Mode
drop down list.*
If you select
Address
input field.
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: Not available for SX10 TC7.1 version.
Configuration
Configuration
tab and select
System
settings from the left column.
DateFormat
drop
TimeFormat
Zone
drop down list.
settings from the left column
section select
Auto
or
Manual
in the
Manual,
enter the NTP server address in the
15
Appendices
drop
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contact