Cisco DX series Manuale introduttivo - Pagina 18
Sfoglia online o scarica il pdf Manuale introduttivo per Sistema di conferenze Cisco DX series. Cisco DX series 34. Telepresence video systems
Stampa la pagina
Cisco TelePresence Video Systems
Introduction
Date, time and location
(When not set by a provisioning system)
We recommend you check that the date and time settings
are correct when you set up your video conference system.
The system uses this information for example to time stamp
messages transmitted to gatekeepers and other network
elements.
If you are changing a value setting,
you have to always click
save
to confirm the change.
D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016.
User interfaces
Web interface
Web interface
1. Go to
Setup
settings from the left column.
2. Select your preferred date format, time format, and your
time zone in the corresponding drop down lists.
3. Open the
4. Under the
Mode
drop down list.*
a. If you select
the
Address
b. If you select Off, you have to enter the time and date
manually using either the Touch controller (
> Administrator > Date, Time &
command line interface (xCommand Time DateTime
Set) .
5. To verify the time settings, go to
Open
Time
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: You must set the time manually. The time is not updated automatically.
Setup assistant
tab and select Configuration. Open the
NetworkServices
settings from the left side bar.
NTP
section select Auto,
Manual
or
Off
Manual,
enter the NTP server address in
input field.
Settings
Location) or on the
Setup
and click Status.
status from the left side bar.
18
Touch
Time
in the
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Appendices