Cable Electronics AV700 Manuale di istruzioni - Pagina 2
Sfoglia online o scarica il pdf Manuale di istruzioni per Amplificatore Cable Electronics AV700. Cable Electronics AV700 2. Cable electronics inc. audio/video distribution distribution
Anche per Cable Electronics AV700: Scheda tecnica (2 pagine)
Stampa la pagina
GENERAL INFORMATION
Both models are low noise, low distortion unity gain distribution amplfiers for
line level stereo audio and video baseband signals.
Both models distribute a true one to one signal ratio. There is no loss of signal
from original source to any output.
The model AV400 distributes audio/video to four TVs without loss. The AV700
distributes audio/video to seven TVs.
A
B
A. 15 Volt DC input jack and power indicator. LED lights up when
power is applied.
B. Input Jacks: Connect to original source at corresponding output jacks.
Connections are color coded (red to red, yellow to yellow and white
to white).
C. Output Jacks: Connect to corresponding input jacks of TVs, VCRs, etc.
Connections are color coded.
SAFETY INSTRUCTIONS
Location: Avoid locations with strong vibrations, direct sunlight or intense
heat. Avoid Electrical Shock: Do not handle power cord with wet hands; do not
expose to rain or other moisture. If liquid is spilled on unit, unplug and have
unit serviced at authorized service center. To reduce the risk of electrical
shock, do not remove cover. No user serviceable parts inside.
KEY INFORMATION
The AV400 and 700 units can be looped, cascaded or put in tandem as shown
below without loss of audio/video signals. Audio/Video cables need to be top
quality and can have runs of up to 100 feet between units and 150 feet
between units and TVs.
Common Audio/video Sources:
VCR, CD, Satellite receiver, etc.
C
Audio/Video Source
HIGH PERFORMANCE
AUDIO AND VIDEO
DISTRIBUTION AMPLIFIER
Four Output
True One To One Ratio
CABLE ELECTRONICS, INC.
Model 400
HIGH PERFORMANCE
AUDIO AND VIDEO
DISTRIBUTION AMPLIFIER
Four Output
True One To One Ratio
CABLE ELECTRONICS, INC.
Model 400
HIGH PERFORMANCE
AUDIO AND VIDEO
DISTRIBUTION AMPLIFIER
Four Output
True One To One Ratio
CABLE ELECTRONICS, INC.
Model 400
VIDEO
Gain:
1 Volt, Unterminated 2 Volt
Input Impedance:
75 Ohms +5%
Video Response:
50 Hz to 10 MHz <.4dB
Ch. to Ch. Isolation:
50 Hz to 10 Mhz 32 dB
Out to In Isolation:
50 Hz to 10 MHz 60 dB
Return Loss:
50 Hz to 10 MHz 20 dB
AUDIO
Gain:
Unity
Input Impedance:
22 K Ohm
Output Impedance:
100 Ohm
THD:
0.05% at 1.0 Volts
input level
Frequency Response:
10 to 50 KHz + 1 dB
Channel Separation:
> 75 dB @ 1 KHz
Out to In Isolation:
60 dB
Signal to Noise:
100 dB (re: 2 Volts out)