Cisco MCU 5300 series Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Sistema di conferenze Cisco MCU 5300 series. Cisco MCU 5300 series 14. Telepresence

Configuring the MCU 53x0

1. Ensure power is connected to the MCU 53x0 and the Status LED is green.

2. Connect the console port of the unit to the serial port of your PC using the RJ45 to DB9 cable supplied.

3. Use a serial terminal program, such as Secure CRT or HyperTerminal, to connect to the unit. Set your

terminal software to the following settings:

Baud rate: 38400

Data bits: 8

Parity: none

Stop bits: 1

Flow control: none

4. Press Enter and the following command prompt appears on the terminal:

MCU:>

The default setting for the MCU 53x0 Ethernet ports is auto-sensing mode. If the switch port to which you

connect the MCU 53x0 is not also set to auto-sensing mode, then you need to configure the device's

Ethernet ports to use the same speed and duplex mode.

Only connect to Ethernet Port B if you need to connect the MCU 53x0 to a second subnet.

Both ends of the Ethernet connection must be configured in the same way. For example, either

configure both ends of the link to be auto-sensing or configure both ends to operate at the same speed

and duplex.

Note: To establish a 1000 Mbps connection, both ends of the link must be configured as auto-sensing.

To configure Ethernet Port A, enter the following for auto-sensing mode:

ethertype A auto

or to configure a speed and duplex, use the following command:

ethertype A <10 | 100> <half | full>

For example, to configure a full-duplex 100 Mbps link, enter:

ethertype A 100 full

To display the current configuration and status of the Ethernet ports, enter:

status

The default setting for the MCU 53x0 is to use DHCP to obtain an IP address. You can assign a static IP

address if you prefer, or if a DHCP server is not available. If you want the IP address of the MCU 53x0 to be

assigned by your DHCP server, omit this step.

To assign a static IPv4 address to Port A, use the following command:

static A <IP address> <netmask> [<default gateway address>]

Cisco TelePresence MCU 5300 Series Installation Guide

Page 6 of 14