Argo DD DCI Series Manuale di istruzioni per l'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Condizionatore d'aria Argo DD DCI Series. Argo DD DCI Series 15. Air conditioner without outdoor unit

Stampa la pagina

USING THE REMOTE CONTROL UNIT

EN
HOW TO INSTALL BATTERIES
Remove trhe lid in the rear part of the remote control
l
unit and check the settings of the dipswitch as shown
below:
SWITCHES
Insert two AAA alkaline batteries of 1,5 V-DC making
l
sure that point in the direction marked in the battery
compartment.The displayed time flashes.
Press the ST button and set time.
Remote controller is now ready for operation.
The batteries last about six months. Depending on how
l
much you use the remote control unit.
Remove the batteries if you do not use the remote
control unit for more than one month.
Replace the batteries when the remote control unit
lamp fails to light, or when the air conditioner does not
receive the remote control unit signals.
The batteries of the remote control contain polluted
l
substances exhausted batteries must be disposed
according to the laws in force.
HOW TO REMOVE BATTERIES
Remove the lid.
l
Press the battery
l
t o w a r d
t h e
n e g a t i v e
e n d
and lift it out by
its positive end
(as shown in the
figure).
Remove the other
l
battery in the same
way.
TEMPERATURE SENSOR SELECTOR
Under normal conditions the room temperature is
l
detected and checked by the temperature sensor placed
in the remote controller (I FEEL icon displayed ).This
function is designed to provide a comfortable room
temperature by transmitting the temperature control
command from the location next to you. When using this
function, the remote, control should always be pointed
at the air conditioner, therefore it should be placed in
a position in which it is visible by the indoor unit (for
example, do not put it in a drawer).
It is possible to disable the remote controller room
l
sensor pressing the I FEEL button. In this case the I
FEEL icon on the remote controller display lights off and
only the sensor placed in the air conditioner becomes
active.
NOTE
The remote control unit transmits signals to the
indoor unit each time you press a key and at any
temperature change detected by the IFEEL sensor. In
case of troubles (low batteries, remote control placed
in a position not visible by the indoor unit,...) room
temperature control is automatically switched to the
sensor of the indoor unit. In this case, the temperature
around the remote control unit may differ from the
temperature detected in the air conditioner position.
OPERATION WITH THE REMOTE CONTROL UNIT
When using the remote control unit, always point the
remote control unit directly at the air conditioner receiver.
HOW TO TURN ON OR OFF THE AIR CONDITIONER
Press the ON/OFF button on the remote control unit to
turn the air conditioner on or off. The operation lamp will
light up, indicating the unit is in operation and vice versa.
NOTE
The air conditioner still operates for 30 seconds after
receiving the switch off signal.
TRANSMITTER
REMOTE
CONTROL UNIT
4
UNIT
RECEIVER