Cisco TelePresence IX5200 Prima impostazione - Pagina 3
Sfoglia online o scarica il pdf Prima impostazione per Sistema di conferenze Cisco TelePresence IX5200. Cisco TelePresence IX5200 40.
Anche per Cisco TelePresence IX5200: Manuale d'uso rapido (15 pagine), Manuale d'uso (26 pagine), Manuale di installazione (36 pagine)
Stampa la pagina
Some browsers do not allow you to navigate directly to the Configuration page. If you have any
Tip
problems, click Monitoring, then click Configuration.
After performing the preceding changes, but before beginning first-time setup, you must download the
latest IX software version from Cisco.com and load it to your IX system. Obtain the IX software from
this link (Cisco.com sign-in ID required):
https://software.cisco.com/download/navigator.html
Navigate to the IX release software using the path Products > Collaboration Endpoints >
TelePresence IX 5000 Series and select the model for your system. On the Download Software page,
select the latest release.
If your system has software from a release prior to 8.0.3, you MUST upgrade to 8.0.3 or 8.0.4 or 8.0.5
Note
BEFORE you upgrade to 8.1.x. A direct upgrade from a pre-8.0.3 release to 8.1.x will not work.
While the system software is upgrading for the first time, you might see the following symptoms, which
do not indicate a problem:
•
•
•
Do not perform any corrective actions, and wait for the upgrade to complete.
For more information, see the
TelePresence System" section on page
Required First Time Power-On and Software Installation
Procedure
After you physically install your system, but before you power it on, configure your system using the
following procedure.
Failure to complete these steps, or failure to complete them in the correct order, can cause either the
switch in the table or the Touch 10 controllers to fail.
Make sure that there is no power to the table structure.
Step 1
Either make sure that the PDU in the table structure is turned to the "OFF" position, or unplug the plug
to the wall.
Disconnect the Touch 10 controllers by unplugging the Ethernet cable from the back of the device.
Step 2
OL-27038-01
If the IX system has an IP address assigned by DHCP, use that address from your network.
–
Otherwise, connect your laptop to the EX1 Ethernet jack, and use 169.254.1.1 for the IP
–
address. (You may need to assign a static IP address to your laptop in the 169.254.1.X subnet.)
Navigate to Configuration > Call Control Manager, and click Delete Certificate Trust List.
–
For more information, see the
–
Interface"
section of the
The progress bar might freeze.
The system reboots several times.
The screen changes from the blue progress screen, with progress bar, to a blank screen.
Required First Time Power-On and Software Installation Procedure
"Certificates"
section of the
Administration Guide for Cisco TelePresence Software Release IX
"Configuring Cisco Unified Communications Manager for Your Cisco
5.
Cisco TelePresence IX5000 and IX5200 First-Time Setup
"Understanding the Fields In the
8.
3