Cisco TelePresence MX700 Manuale di installazione - Pagina 30

Sfoglia online o scarica il pdf Manuale di installazione per Sistema di conferenze Cisco TelePresence MX700. Cisco TelePresence MX700 32. Single camera on a free standing floor stand or a floor stand secured to the wall
Anche per Cisco TelePresence MX700: Manuale di installazione (32 pagine), Manuale di avvio rapido (12 pagine), Manuale di installazione (28 pagine), Manuale di installazione (29 pagine), Manuale di riferimento rapido (2 pagine), Manuale (45 pagine), Manuale (45 pagine), Manuale di installazione (29 pagine), Manuale di riferimento rapido (2 pagine), Manuale di riferimento rapido (2 pagine), Manuale introduttivo (46 pagine)

Installation guide for Cisco TelePresence MX700 Single camera - Wall mount

Start up the system

•

Remove the protection foil from the displays.

•

Make sure that the camera can move freely.

•

Insert the network and power cables into the wall outlets.

•

Switch on the system.

The power switch is located directly below the codec, next to the

power connector.

Wait a few minutes while the system starts up. The start-up may

include automatic software upgrade and restart of Touch 10 and

camera.

If the right monitor does not turn on after the start-up sequence,

check that the power cable between the monitors are properly

connected (refer to step 10 and step 12).

•

Follow the instructions on the Touch controller.

Cisco Spark: To find more information on how to get started with

Spark registered systems, visit

for Getting Started articles for room systems.

Other services: For further information on set-up and configuration,

download the Getting Started Guide from the Cisco web site,

http://www.cisco.com/go/mx-docs

http://help.ciscospark.com

and look

Page 30