Cisco TelePresence SX10 Manuale introduttivo - Pagina 27

Sfoglia online o scarica il pdf Manuale introduttivo per Sistema di conferenze Cisco TelePresence SX10. Cisco TelePresence SX10 46. In-room control on touch 10
Anche per Cisco TelePresence SX10: Manuale di installazione (8 pagine), Manuale d'uso (26 pagine), Manuale rapido (2 pagine), Manuale d'uso (34 pagine), Manuale d'uso (29 pagine), Manuale d'uso preliminare (9 pagine), Manuale d'uso (38 pagine), Manuale di installazione (8 pagine), Manuale d'uso (2 pagine), Manuale d'uso (37 pagine), Manuale (45 pagine), Manuale (45 pagine), Manuale di installazione (2 pagine), Manuale d'uso (34 pagine), Manuale d'uso (5 pagine), Manuale d'uso (38 pagine), Manuale d'uso (38 pagine), Manuale rapido (2 pagine)

Stampa la pagina

Cisco TelePresence SX10 Manuale introduttivo

Cisco TelePresence Video Systems

Contents

Setting the date, time and location

(When not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among other

things this information is used to time stamp messages transmit-

ted to gatekeepers and other network elements.

If you operate your system using the Touch controller, the time

is shown in the top right corner of the Touch controller display;

if you operate your system using a remote control, the time

and date is shown in the top right corner of the main display.

If you are changing a value setting,

you have to always click

save

to confirm the change.

Back to task overview

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

1. Go to the

Configuration

Open the

2. Select your preferred date format in the

down list.

3. Select your preferred time format in the

down list.

4. Select your time zone in the

5. Open the

* NTP mode:

Auto: The time is regularly updated using an NTP server. The NTP server

address is automatically obtained from the network (DHCP).

Manual: The time is regularly updated using an NTP server. You must

manually enter the NTP server address.

Off: You must set the time manually. The time is not updated automatically.

Configuration

tab and select

System

Configuration.

Time

settings from the left column.

DateFormat

TimeFormat

OlsonZone

drop down list.

NetworkServices

settings from the left column.

Appendices

drop

Getting Started Guide

Contacts