Cisco 2610 - Router - EN Manuale di avvio rapido - Pagina 4

Sfoglia online o scarica il pdf Manuale di avvio rapido per Hardware di rete Cisco 2610 - Router - EN. Cisco 2610 - Router - EN 19. Cisco 2610: quick start
Anche per Cisco 2610 - Router - EN: Scheda tecnica (8 pagine)

Stampa la pagina
2

Connect Cables

MODEMS
16AM
IN USE

Installing a Network Module

Use this procedure, if required, to install an 8- or
16-port analog modem network module in a
Cisco 2610 router.
Look for a network module in the slot labeled 1 on
the left-rear of the router. If there is an analog
modem network module already installed, continue
4
to cable the router as described in this guide.
If you need to install an analog modem network
module, follow this procedure:
1
Use a Phillips screwdriver to remove the screws
that hold the metal plate over the network
module slot cover and remove the metal
covering plate.
2
Hold the network module by the handle and line
the module up with the guides on either side of
the slot.
3
Push the module into place until the edge
connector is securely seated in the connector on
the motherboard. Ensure that each of the
module's captive screws line up with their hole in
the chassis.
4
Secure the captive mounting screws into the
holes of the chassis using a Phillips screwdriver.
15
14
13
12
11
10
9
8
IN USE
7
6
5
4
3
2
1
0
EN
SERIAL 1
SERIAL 1
SERIAL 0
CONN
WIC
SERIAL 0
CONN
2A/S
WIC
CONN
CONN
2T
SEE MANUAL BEFORE INSTALLATION
SEE MANUAL BEFORE INSTALLATION
LINK
ETHERNE T 0 ACT
CONSOLE
AUX
5
Connect the appropriate network module
cable(s) to your network.
For information on connecting network modules,
refer to the Cisco Network Modules Hardware
Installation Guide included in your router package.
100-240V– 1A
50/60 Hz 47 W