Cisco 5500 Series Manuale di installazione - Pagina 9
Sfoglia online o scarica il pdf Manuale di installazione per Hardware di rete Cisco 5500 Series. Cisco 5500 Series 34. Cisco 8500 series
wireless lan controller
Anche per Cisco 5500 Series: Manuale di configurazione (40 pagine), Manuale (19 pagine), Manuale di configurazione (50 pagine)
Stampa la pagina
The following additional items (not found in the accessory kit) are required to ground the chassis:
•
•
•
Initial System Configuration Information
Obtain the following initial configuration parameters from your wireless LAN or network administrator:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
78-18998-01
Grounding cable (6 AWG recommended), sized according to local and national installation
requirements; the required length depends on the proximity of the switch to proper grounding
facilities
Crimping tool large enough to accommodate girth of lug
Wire-stripping tool
A system (controller) name.
An administrative username and password. The default administrative username and password are
admin and admin, respectively.
A service port interface IP address configuration protocol (none or DHCP).
A management interface (DS port or network interface port) IP address.
The service port interface and management interface must be on different subnets.
Note
A management interface netmask address.
A management interface default router IP address.
A VLAN identifier if the management interface is assigned to a VLAN, or 0 for an untagged VLAN.
Distribution system physical port number—1 through 8 for front panel Gigabit Ethernet ports.
IP address of the default DHCP server that will supply IP addresses to clients.
The Control And Provisioning of Wireless Access Points Protocol (CAPWAP) transport mode
(Layer 3).
A virtual gateway IP address (a fictitious, unassigned IP address, such as 1.1.1.1, used by all Cisco
wireless LAN controller Layer 3 security and mobility managers).
A Cisco wireless LAN controller mobility group name, if required.
An 802.11 network name (SSID) for WLAN 1. This is the default SSID that the access points use
when they join with the controller.
Whether or not to allow static IP addresses from clients.
Yes is more convenient, but has lower security (session can be hijacked).
–
No is less convenient, but has higher security and works well for Windows XP devices.
–
RADIUS server IP address, communications port, and secret (if you are configuring a RADIUS
server).
The country code for this installation. Refer to the Cisco Wireless LAN Controller Configuration
Guide for country code information. This guide is available at cisco.com.
Status of the 802.11a, 802.11b, 802.11g, and 802.11n networks (enabled or disabled).
Status of radio resource management (RRM) (enabled or disabled).
Unpacking and Installing the Controller
Cisco 5500 Series Wireless Controller Installation Guide
9