Cisco 7513 Series Mantenimento - Pagina 18

Sfoglia online o scarica il pdf Mantenimento per Hardware di rete Cisco 7513 Series. Cisco 7513 Series 20. Chassis replacement
Anche per Cisco 7513 Series: Manuale di avvio rapido (44 pagine), Manuale di istruzioni per la sostituzione (26 pagine), Scheda tecnica (11 pagine), Manuale (30 pagine), Manuale di istruzioni per la sostituzione (19 pagine), Manuale di istruzioni per la sostituzione (22 pagine)

Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576

Figure 7-16

Place the CI in an antistatic bag.

Step 5

This completes the CI removal procedure.

Use the following procedure to replace the CI:

Attach an ESD-preventive strap between you and an unpainted chassis surface.

Step 1

Position the CI in the orientation shown in

Step 2

Figure 7-16

holes in the corners of the board with the four standoffs.

Caution

Access to the backplane socket is partially blocked by a chassis panel. Two of the screws are below this

panel and two are above it. To avoid damaging CI components when you install the CI, do not hit the CI

against the chassis panel.

Place your fingers around the edges of the CI and carefully guide it over the chassis panel (see

Step 3

Figure 7-15

straight in toward the backplane until the CI connector is fully seated in the backplane socket and the

standoff screw holes are aligned with the standoffs. It might be necessary to rock the connectors gently

into place.

Step 4

Install the four Phillips screws that secure the CI and gently tighten them. Do not overtighten these

screws.

Cisco 7500 Series Installation and Configuration Guide

7-18

Removing and Replacing the Cisco 7576 CI (Cutaway View)

for the Cisco 7576. Position the CI over the backplane connector and align the four standoff

for the Cisco 7513 and Cisco 7513-MX, and

Chapter 7

Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router

Chassis interface

standoffs (4)

Figure 7-15

for the Cisco 7513 and Cisco 7513-MX, and

Figure 7-16

for the Cisco 7576), and push it

OL-5008-03 B0