Argo DRY BABY 11 Manuale di istruzioni per l'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Deumidificatore Argo DRY BABY 11. Argo DRY BABY 11 8.
Anche per Argo DRY BABY 11: Manuale di istruzioni per l'uso (6 pagine), Manuale di istruzioni per l'uso (10 pagine)

3. RELATIVE HUMIDITY ADJUSTER BUTTON

buttons, or you can set the appliance to continuous drain (CO) – maximum dehumidification.

4. DISPLAY

shows the relative humidity setting.

5. FAN SPEED BUTTON: press this button to set the fan speed (LOW / HIGH).

6. TIMER ON/OFF BUTTON: delayed on/off button (2 or 4 hour delay).

TIMER LED: shows the timer setting (2 or 4 hours).

HIGH/LOW FAN SPEED LED: shows the fan speed: HIGH or LOW.

TANK FULL LED: when the tank is full, the TANK FULL LED comes on and the appliance stops running. A 10 second

beep sounds. Remove the tank and empty it (as indicated in "HOW TO ELIMINATE CONDENSATION"), the restore it;

the dehumidifier will start running again.

STAND BY LED.

CONTINUOUS LED: shows that the dehumidifier is running in continuous mode.

FILTER RESET LED: indicates that the filter must be cleaned.

DEFROST: the dehumidifier is designed to operate at ambient temperatures from + 5°C to + 35°C.

If it is operated at low temperatures, ice may form on the evaporator, degrading its operation.

When this happens, the dehumidifier goes into defrost mode. The compressor stops, but the fan continues running.

We recommend not using the dehumidifier in room temperatures lower than 5°C.

AUTO RESTART: the dehumidifier starts up again after a power failure.

MEMORY FUNCTION: the dehumidifier maintains its settings during a power failure.

MAINTENANCE OF THE HUMIDIFIER'S EXTERIOR SURFACE

Warning

Always pull the dehumidifier's plug out of the power socket before cleaning it, to prevent electric

shock and malfunction.

Warning

Do not wet the appliance or immerse it in water, otherwise electric shocks may occur.

Use a damp and soft cloth to clean the exterior surface of the dehumidifier.

Do not use solvents, petrol, xylene, talcum powder or brushes to clean the unit: these may damage

the surface or colour of the casing.

We advise removing the tank once every few weeks to prevent mould and bacteria forming on it. Fill the tank with clean

water a small amount of detergent; swill the water around in it, then it out and rinse it thoroughly.

V 09/16

the humidity can be set from 35% to 80% in 5% steps with the + and -

CLEANING AND MAINTENANCE

CLEANING THE WATER TANK