ACU-RITE MILLPWRG2 Manuale di avvio rapido - Pagina 3

Sfoglia online o scarica il pdf Manuale di avvio rapido per Strumenti di misura ACU-RITE MILLPWRG2. ACU-RITE MILLPWRG2 3.

Graphics – The location of holes will be displayed with a cross-hair if tool diameter is too small

to be seen.

The run-time travel limit error message text was changed from "Limit switch" text to "Software

limit reached". Updated Cause: and Action: text in the Message Log

When defining an arc by center point, the system would not calculate the Minor/Major value of

the Radius field this has been updated and will calculate correctly.

Radial Slot cycle retracts to Z Retract height between passes.

AMIG2: Corrected an issue in which if an external e-stop or external axis limit switch was

already triggered at startup, it was not detected.

We did not release R4SP1 Offline software a new version is now available for R4SP2 and can

be downloaded from the ACU-RITE website.

Ordering of DXF entities has been corrected.

Corrected an issue in which a newly loaded DXF was not treated as a modified program, and

thus could not be saved without making some additional change.

Softkey states (pressed/released) were corrected to match dialog fields. 1. Change Step - Z

End, Z Feed, Feed, Z Type, and Offset 2. Engrave Arc - Arc Up/Down

The axis fields in the Preset dialog use the PresetField type. The only effect is the Abs preset

type is now indicated in the dialog.

Access to areas like Datum and Move Table is now prevented if a severe error is active which

makes them unusable at that time.

Corrected an issue in Installation Setup in which setting the Z-Axis to "Rotary" did not save the

correct default settings for the standard rotary encoder motor assembly.

Corrected an error in which the W-Axis movement monitoring was not activated if the user

started running a program from the PGM/Graphics mode. Switching to DRO mode at any point

did activate it, but it was not active until then.

If any issues are encountered, please contact your service representative for assistance or

contact technical support at

if you have any questions.