Argo LILIUM ART 11 Manuale di istruzioni per l'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Deumidificatore Argo LILIUM ART 11. Argo LILIUM ART 11 14.

Auto mode: When the humidity in the room is 3% higher than the set one, the ventilation and the compressor start to

work after 3 minutes. On the other hand, when the humidity in the room is 3% lower than the set one, the compressor

stops while the ventilation continues for a short period of time.

In Auto mode it is possible to adjust the ventilation and humidity level.

Continuous mode: The unit works continuously, but it is not possible to adjust the humidity level and ventilation.

Sleep mode: Press the Mode button on the control panel to activate this function, the symbol lights up on the display. If

no selections are made on the control panel within 10 seconds, the display turns off and the fan speed changes from

high to low. To reactivate the lighting, press any button on the control panel. Press the Mode button again to deactivate

this function.

In sleep mode, the fan speed cannot be adjusted but the humidity level can be adjusted.

3. HUM BUTTON (HUMIDITY): press this button to adjust the desired humidity in the room (from 30 to 80%) in steps of

5% By keeping this button pressed for a long time, the humidity level in the room is shown on the display.

4. TIMER BUTTON: allows you to program switching on (if the unit is off) or switching off (if the unit is on) from 0 to 24

hours. Each time the button is pressed, the adjustment interval corresponds to 1 hour, and it is possible to view the time

set on the display, the symbol on the display remains lit during the set time interval. It is always possible to view the set

time by pressing the Timer button, then the display will return to showing the humidity level detected in the environment.

To deactivate the Timer, "00" must appear on the display (flashes 4 times), and the Timer symbol on the display will turn

off.

5. SPEED BUTTON (VENTILATION SPEED): It is possible to adjust the ventilation speed only in Auto mode. Press this

button to adjust the speed from high to low, the corresponding symbols will light up on the display according to the

selection made.

6. LOCK BUTTON: Long press of this button activates the control panel lock function, the corresponding symbol on the

display lights up, and it is no longer possible to make selections on the control panel. Long press this button again to

deactivate this function, the symbol goes off on the display.

When the appliance is switched off, the child lock function is automatically deactivated.

MEMORY FUNCTION: the dehumidifier starts up again after a power failure keeping last settings.

COLOR LED

On the front panel of the dehumidifier there is a LED that shows different colors based on the humidity level detected in the

room:

Blue = Ambient humidity below 45%

Green = Ambient humidity between 45% and 65%

Red = Ambient humidity above 65%

If E0, E2, CL, CH, LO, HI appear on the display on the control panel, the color of the LED will be red.

(for error codes refer to the troubleshooting section).

MAINTENANCE OF THE HUMIDIFIER'S EXTERIOR SURFACE

Warning

Always pull the dehumidifier's plug out of the power socket before cleaning it, to prevent electric

shock and malfunction.

Warning

Do not wet the appliance or immerse it in water, otherwise electric shocks may occur.

Use a damp and soft cloth to clean the exterior surface of the dehumidifier.

Do not use solvents, petrol, xylene, talcum powder or brushes to clean the unit: these may damage

the surface or colour of the casing.

V 02/22

CLEANING AND MAINTENANCE