Cisco ACIP-SM= Manuale di installazione e configurazione - Pagina 19
Sfoglia online o scarica il pdf Manuale di installazione e configurazione per Hardware di rete Cisco ACIP-SM=. Cisco ACIP-SM= 33. Atm cable interface processor (acip)
Stampa la pagina
Step 6
Step 7
If an error message displays on the console terminal, refer to the appropriate reference publication
for error message definitions. If you experience other problems that you are unable to solve, contact
a service representative for assistance.
This completes the procedure for checking initial ACIP status.
Using show Commands to Verify Interface Status
The show version command displays the current hardware configuration of the router, including the
system software version that is currently loaded and running. The show controller cbus command
lists all interfaces and includes the currently loaded and running microcode version for each. The
show diagbus slot command shows the hardware and board revision of an interface processor in a
designated interface processor slot.
Use the show version command to display the current system software version. In the following
example of the show version command, the running system software is Release 11.2(7)P:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-ITV-M), Released Version 11.2(7)P [biff 265]
Copyright (c) 1986-1997 by cisco Systems, Inc.
Compiled Mon 24-Feb-97 17:20 by biff
Image text-base: 0x600108A0, data-base: 0x606D4000
ROM: System Bootstrap, Version 5.3(16645) [biff 571], RELEASE SOFTWARE
ROM: RSP Software (RSP-BOOT-M), Version 11.2(7)P, RELEASE SOFTWARE (fc1)
Router uptime is 1 day, 18 hours, 42 minutes
System restarted by reload
System image file is "biff/rsp-itv-mz", booted via tftp from 1.1.1.10
cisco RSP2 (R4600) processor with 32768K bytes of memory.
R4600 processor, Implementation 32, Revision 2.0
Last reset from power-on
G.703/E1 software, Version 1.0.
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Chassis Interface.
(additional displayed text not shown)
1 ACIP controller (1 ATM).
1 ATM network interface(s)
(additional displayed text not shown)
125K bytes of non-volatile configuration memory.
8192K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
No slave installed in slot 3.
Configuration register is 0x100
If this installation was a replacement ACIP, use the show interfaces or show controllers
cbus command to verify the status of the ATM interface. (For command descriptions and
examples, refer to the section "Using show Commands to Verify Interface Status" on
page 19.)
When the interface is up, check the activity of the interface with the ACIP LEDs.
(See Figure 11.)
ATM Cable Interface Processor (ACIP) Installation and Configuration
Using show Commands to Verify Interface Status
19