Digitek G-Line Pro Manuale di istruzioni per l'installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Sistema di sicurezza Digitek G-Line Pro. Digitek G-Line Pro 14.

Stampa la pagina
The supplied contact reed switch must be fitted to protect the seat or top-case. It must be installed in such a way as to
detect the opening of the seat/top-case without being accessible from the outside. The trigger threshold must be
carefully set to avoid false alarms. The switch has a self-adhesive backing to assist in mounting, clean and de-grease the
area thoroughly prior to fitting. Fit the magnet on the removable panel/seat adjacent to the switch using the fitting
methods described above. When correctly set; the LED should go out before the panel is removed by 25mm. The
position of the switch/magnet should be adjusted accordingly. If more than one area is to be protected, extra magnets
and switches are available through Digitek Moto-Technic, this is a chargeable extra.
!
ATTENTION: The ENGINE immobilizer 40 second count down is interrupted until the seat/top case is closed!
Alarm Wire Colour
Black wire marked 'M'
Black wire marked 'R'
Orange
Orange
Black wire marked 'G'
Green/Brown
White/Violet
Green
Alarm Wire Colour
Black wire marked 'B1'
Black wire marked 'H1'
Black wire marked 'HB'
Black wire marked 'B'
Black wire marked 'H'

1.4 - Contact Switch Positioning

1.5 – Electrical Connections
Alarm Plug Pin
3
Connect to motorcycle battery negative terminal (Ground)
16
Connect to motorcycle battery positive 12v via supplied 10amp fuse
15
Connect to motorcycle left turn indicator
17
Connect to motorcycle right turn indicator
8
Connect to motorcycle ignition under key (+15)
5
Connect to seat/Top-case contact switch
4
Learning New Device – See section 2.1
11
Electronic Key data line
1.6 - Engine Immobilisation (see diagram 1.9)
Alarm Plug Pin Connection – see wiring diagram section 1.9
13
Connect to motorcycle starter switch (see diagram 1.9)
12
Connect to motorcycle starter wire (See section 1.9)
14
Not used – cut and insulate.
1
Connect to positive under key wire being cut; i.e. fuel/ign (See diag 1.9)
10
Connect to other side of positive under key wire being cut , See diag 1.9
www.digitek-moto.com
Rev05/KM/271113/DigProInst
G-Line 'Pro' Alarm
System
Connection
7/14