Argo WALLNER FXD85B Manuale di istruzioni - Pagina 14
Sfoglia online o scarica il pdf Manuale di istruzioni per Tritacarte Argo WALLNER FXD85B. Argo WALLNER FXD85B 16.
Stampa la pagina
PROBLEm SOLVING
problems
No operation
No operation after
long time operation
stop at shredding
excess squeaking
and rubbing noise
Paper jam
mALFUNtION / mAINtENANCE
If any faults should appear, please pass the machine along with the warranty card to the
seller or closest authorised dealer. The machine might be passed futher, thus the user sho-
uld maintain the original and complete packaging. In cases when the machine is passed for
repair in a not original or incomplete package, the risks of futher damages that might arise
in transportation are on the user's side. Thus, in such a case, it is in the user's best interest
to make the best possible replacement packaging.
© ArGO s.A.
EN
checklists
The power plug is properly
inserted to main supply?
switch is set at „I" position?
switch at „l" position but power
light off?
Basket at stand but power light
off?
No operation when insert paper?
checked above, but still no
operation and no power light?
Power lamp is on?
Machine was continuously
shredding for a longer time?
Without oiling to the cutting
system periodically,
- squeaking and rubbing noise at
shredding may appear.
- exceeding the shredding
capacity
- The paper is not fed squarely
into the feed opening.
14
solutions
Fully put the power plug to the
outlet.
set switch to „I" position for
operation.
check if the basket is out of
stand. Put basket back to stand.
Take the basket out, check the
plug and put it back to place.
Paper should be inserted to
trigger the sensor at center.
send back to your local service
for repair.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
Perform the cutter oiling
instruction to lubricate the
cutting system.
set switch to „rev" for reverse
running and frees excess
paper. Then set to „I" for cutting
the remainder of paper left in
the cutting system. If serious
jam occurred, send back to
local service for repair.
www.argo.pl