Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr Manuale di servizio - Pagina 30
Sfoglia online o scarica il pdf Manuale di servizio per Fotocamera digitale Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr. Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr 30. Interchangeable lens digital camera/zoom lens kit
Anche per Sony SLT-A55V - alpha; Translucent Mirror Technology™ Dslr: Manuale delle funzioni (7 pagine), Specifiche tecniche (2 pagine)
Stampa la pagina
3-2. CLEANING PROCEDURE OF OLPF
<Preparation for Remedy>
If you use the new Jig (J-6082-663-A) below, make sure to clean the CCD Cleaning Jig (Tip) below before using, please.
Note: Protection sheet is for preventing the scratch of a surface on the Jig (Tip).
The protection sheet may be come off the Jig when you take the Jig from a bag, but it is no problem.
CCD Cleaning Jig
<Cleaning Procedure for Tip of CCD Cleaning Jig>
1. Put the two cleaning cloths on a tray like below.
1 Souse the one cleaning cloth in ethyl alcohol.
2 Put the other cleaning cloth on a tray as it is dry.
2. Dab the tip of CCD cleaning jig at the cleaning cloth of 1 5 or 6 times.
* Do not slide the tip from right to left or up and down while dabbing.
3. Dab the tip of CCD cleaning jig at the cleaning cloth of 2 5 or 6 times.
* Do not slide from right to left or up and down while dabbing.
4. Wait until the tip will be dried completely.
SLT-A33/A33L/A33Y/A55/A55V/A55L/A55VL/A55VY_L2
Protection Sheet
CCD Cleaning Jig (Tip)
CCD Cleaning Jig (New)
(J-6082-663-A)
1 Souse the cleaning
cloth in ethyl alcohol.
2 The dry cleaning cloth.
<Cleaning Procedure for the OLPF>
1. Clean up the tip of CCD cleaning jig.
2. Press the Mirror Lock Lever to raise the P.O.I.
3. Dab the tip of CCD cleaning jig at the OLPF, and pull up straight.
* Do not slide from right to left or up and down while dabbing.
4. Repeat "3" several times to clean up.
5. According to service manual, check if there is dirt on the CCD.
<ATTENTION>
If you cannot remove dirt with remedy above, cleaning by the following jig are used.
Soak a small amount of EE3310 (Liquid cleaner) after wrapping the cleaning cloth (J-6082-636-A) around the cleaning jig (J-6082-635-A).
Cleaning Cloth
(J-6082-636-A)
3-5E
OLPF
Mirror Lock Lever
Cut
EE3310
Cleaning Jig
(J-6082-635-A)