Cisco ASA 5506W-X Manuale di configurazione

Sfoglia online o scarica il pdf Manuale di configurazione per Hardware di rete Cisco ASA 5506W-X. Cisco ASA 5506W-X 13. Threat defense reimage guide
Anche per Cisco ASA 5506W-X: Manuale di avvio rapido (10 pagine), Manuale di avvio rapido (14 pagine), Manuale di configurazione facile (11 pagine), Manuale del software (37 pagine), Montare e collegare (12 pagine), Manuale di installazione (46 pagine), Montare il telaio (10 pagine)

Contents

Introduction

Prerequisites

Requirements

Components Used

Network Diagrams

Configure

Step 1. Modify Interface IP configuration on ASA

Step 2. Modify DHCP pool settings on both inside and wifi interfaces

Step 3. Specify DNS server to pass to inside and WiFI DHCP clients

Step 4. Modify HTTP access configuration on the ASA for Adaptive Security Device Manager

(ASDM) access:

Step 5. Modify Interface IP for Access Point Management in WLAN console (interface BVI1):

Step 6. Modify default-gateway on WAP

Step 7. Modify the FirePOWER Module Management IP Address (Optional)

If the ASA Management1/1 interface is connected to an inside switch:

If the ASA is NOT connected to an inside switch:

Step 8. Connect to AP GUI to enable radios and set other WAP configuration

WAP CLI Configuration for a single wireless VLAN using modified IP ranges

Configurations

ASA Configuration

Aironet WAP Configuration (without the example SSID config)

FirePOWER Module Configuration (with inside switch)

FirePOWER Module Configuration (without inside switch)

Verify

Configure DHCP with Multiple Wireless VLANs

Step 1. Remove Existing DHCP configuration on Gig1/9

Step 2. Create Subinterfaces for Each VLAN on Gig1/9

Step 3. Designate a DHCP pool for each VLAN

Step 4. Configure the Access Point SSIDs, save the config, and reset the module

Troubleshoot

Introduction

This document describes how to perform initial installation and configuration of a Cisco Adaptive

Security Appliance (ASA) 5506W-X device when the default IP addressing scheme needs to be

modified to fit into an existing network or if multiple wireless VLANs are required. There are

several configuration changes that are required when modifying the default IP addresses in order

to access the wireless access point (WAP) as well as ensure that other services (such as DHCP)

continue to function as expected. In addition, this document provides some CLI configuration

examples for the integrated Wireless Access Point (WAP) to make it easier to complete initial

configuration of the WAP. This document is intended to supplement the existing Cisco ASA 5506-

X Quick Start guide available on the

Cisco

website.