ACU-RITE Mill PWR G2 Aggiornamento software - Pagina 3

Sfoglia online o scarica il pdf Aggiornamento software per Mixer musicale ACU-RITE Mill PWR G2. ACU-RITE Mill PWR G2 3.
Anche per ACU-RITE Mill PWR G2: Aggiornamento software (7 pagine), Aggiornamento software (3 pagine), Aggiornamento software (5 pagine), Aggiornamento software (5 pagine), Aggiornamento software (6 pagine), Aggiornamento software (5 pagine), Aggiornamento software (3 pagine), Aggiornamento software (6 pagine)

Confirm that your count directions are correct.

Press the SETUP hard key, then the "Install Setup" soft key, enter passcode 8891, press

ENTER

In the "Installation" dialogue, scroll down to the last option "Machine Functions" and

press ENTER

Configure the dialog to match your machine Note:(only required if special machine

function options are installed like demo, ami, guards, etc.)

Press the USE hard key, then press the "Save Changes" soft key

After a moment, you will get a reboot prompt

Acknowledge the reboot and you are all done at the next startup

These enhancements/changes were made:

1. Pocket cycles dialogs have separate fields for side and bottom finish allowances.

2. With legacy programs, finish cut value is applied to both side and bottom finishes.

3. Enable Circle Center option under the Probe soft key (XY fields only).

4. Includes a hardware detection feature that will allow for future software updates.

5. AUX Function step does not break path continuity when it neighbors a Blend

step.

6. The max feedrate override setting in Job Setup now correctly enforces the

acceptable range of 150% to 200%.

7. Corrected an issue which enabled the user to move the cursor in the active

program step listing while the program is running.

8. Corrected an issue in which the block form for a G-code program could be

calculated incorrectly when loaded, after the same program had been

previously loaded, and modified, but not saved.

9. If not required, the tool step only prompts for a tool change if the

programmed tool does not match the current tool.

If any issues are encountered, please contact your service representative for assistance or

contact technical support at

if you have any questions.