Argo X5 Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Macchina rilegatrice Argo X5. Argo X5 17. 2-in-1

wire closing channel

Micro adjustment knob

wire closure control

note!

Assemble the punching handle with the provided Allen wrench and Allen screw. Set the

punching switch with the punching handle at full upright position. Insert paper for pun-

ching only after you finish setting up the punching switch.

operation gUide

Place the machine on a stable and safe place before using.

pUncHing - for BotH plastic comB Binding and wire comB Binding

Set the punching switch for required type of comb.

Set the punching margin control at the desired position.

Set the paper limiter at the desired position.

Push paper (max. 20 sheets) into the paper entry. Pull the punching handle all the

way down until it stops to punch completely through.

Push back the punching handle to its original upright position. Remove punched

sheets.

Extra large format punching guide: set the paper limiter along the punching table.

Extra large format punching guide: on the extra large format punching guide by

pulling the pin adequate to the chosen type of comb.

Punch the document by moving the paper from right to left, placing the last hole

in the pin (adequate to chosen type of comb). Align the paper into the paper entry

properly, it will allow you to do continuous punching accurately.

Empty the waste tray at the right side of the machine. Frequent clearance is required.

waste tray

Allen screw

Allen wrench