Digitone proseries blocker Manuale operativo - Pagina 2
Sfoglia online o scarica il pdf Manuale operativo per Telefono cellulare Digitone proseries blocker. Digitone proseries blocker 17. Automatically blocks and routes screened calls with caller id
Stampa la pagina
Digitone ProSeries Blocker
Setup
™
Thank you for choosing Digitone's ProSeries Blocker™ (DPB) model as your Personal Communicator.
Digitone Communications is confident that you will find Digitone's unique preset features and flexibility
are just the answer for your communications needs. Just connect your telephone and you're ready to go.
You don't need to set any codes as Digitone's DPB can operate right out of the box.
No Battery Backup is Needed -
If there is a power outage, all of the program settings remain intact.
1. Connect the supplied line cord to your telephone wall jack and then to the Line Port on the DPB. You
must connect the Line cord and your phone to the correct ports in order for the DPB to operate properly.
Initially, "Connect to Line Service" will show on the display until the Line cord is plugged into the LINE
port. "Connect to Line Service" will also display if the Line cord is disconnected afterwards.
2. Plug the small end of the Power Supply into the port labeled "24VDC" on the DPB, next plug in the
Power Supply to a standard wall receptacle.
3. Connect your combo Phone/Answer Machine system to the TEL phone port of the DPB and set to 3-5
rings. Note if you are using Voice Mail services from your phone company, then don't enable any
answering devices there in your home or office. Set the Voice Mail Ring Count to 6 or 7 rings.
4. For SELECT Mode or OPX enabled calls, connect an answer machine to any phone wall plate and set
the answer delay to 4-6 rings, or 1-2 rings greater than the answering device in the TEL phone port.
This separate answer machine (or phone company voice mail) will capture any uninvited calls not
answered by the Combo Phone/Answering device in the TEL phone port.
1