ACU-RITE SENC 150 Manuale di installazione - Pagina 5
Sfoglia online o scarica il pdf Manuale di installazione per Convertitore multimediale ACU-RITE SENC 150. ACU-RITE SENC 150 6. Chevalier fsg-2a 1224 surface grinder cross feed “x” axis
Anche per ACU-RITE SENC 150: Manuale di installazione (8 pagine), Manuale di riferimento (20 pagine), Manuale di installazione (4 pagine), Manuale di istruzioni (12 pagine)
Stampa la paginaSENC 150
Encoder orientation ...
Saddle
Spacer
Knee
•
These instructions will guide you through installing
the encoder as shown in this view.
Cable exit ...
Plug
Cover plate
T-10 Torx screw (2)
•
Determine the cable exit direction before installing
the encoder.
•
To change the cable exit direction; remove the cover
plate and rotate the cable 180°.
Encoder / Spar installation ...
*M6 Flat washer (2)
•
Attach the spar to the knee with the standoffs. Much
older Bridgeport machines were tapped for a 3/16-18.
Two threaded inserts are provided for these older
mills. Some machines have the spot faced surfaces
epoxied over and will need to be cleaned out
completely.
P.N. 385072-214 Ed C 11/05
Spar
Encoder Assembly
Reading head
bracket
Reading head
Vinyl cable grommet
Armor cable hex crimp
1/4-20 1-1/4" BHCS (2)
Standoff (2)
Spar
Installation Manual 385072-41
Encoder Installation Manual For: Bpt. Vert. Knee Milll
Cross Feed Y Axis - Right hand side
.010" TIR of the axis travel or
top surface of ways
1/4-20 x 5/8"
FHCS
•
Align the spar top and front surface to the axis
travel.
•
Insert and center the encoder in the spar from end to
end as done previously.
•
Tighten set screws to secure in place.
•
With the saddle at its center of travel, attach the
bracket to the saddle.
2
Align to within
M4 Set screws
Encoder
Flush side (1 & 2)
* 1/4-20 x 1" BHCS
& .09" Flat washer (2)
Acu-Rite Companies Inc.