Digitrax DN163K1a Manuale di avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale di avvio rapido per Convertitore multimediale Digitrax DN163K1a. Digitrax DN163K1a 8. N scale mobile decoder. dcc plug 'n play 1.5 amp/2.0 amp peak 6 fx3 functions, 0.5 amp

Stampa la pagina
D D
igitrax
Run Your Trains, Not Your Track!
Parts List
1 DN163K1a Decoder

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, instal-
lation instructions, programming and technical information. Digitrax manuals
and instructions are updated periodically. Please visit www.digitrax.com for the
latest versions, technical updates and additional locomotive-specific installation
instructions.
Installation Instructions - Kato SD-4 4 0 Locomotive
1. Carefully remove the loco-
motive's shell from the
frame. Notice the orientation
of the light board inside so
that you can install the new
decoder in the same orienta-
tion.
2. Carefully remove the factory
light board by sliding it
toward the back of the loco-
motive and out form under
the frame clips. Then gently
lift the board out of the
frame. Be careful not to bend
the motor contacts. Apply a
small piece of Kapton tape to
frame above motor. Figure 2.
3. Install the DN163K1a
decoder by tilting it slightly
as you insert the front cor-
ners into the forward frame
clips. Press the decoder
motor clips down over the
motor contacts and slide the
decoder board forward so the
board's corners are under the
frame clips. Figure 3
5. Replace the locomotive shell.
Digitrax decoders are set up
with configuration variable
(CV) default values so you
can run your locomotive
right away using address 03.
©2004 Digitrax, Inc
C C
C C
ommand
ontrol
1 Instruction sheet
Factory
Light board
Figure 1: Remove loco shell
Apply
Kapton Tape for
insulation
Motor contact -
1 each side
Figure 2: Slide the light board from
under frame clips to remove light board
Figure 3:
Place decoder in frame, sliding
under frame clips.
www.digitrax.com
Light
shroud
frame clips
frame clips
2