argon audio TT-4 Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Giradischi argon audio TT-4. argon audio TT-4 9.

Turntable Platter and Belt Setup

1. Install the drive belt over the inner ring under the platter and make

sure it won't fall off during the setup.

2. Place the platter through the turntable

spindle, then rotate the platter until you

see the drive motor pulley through the

window at the top left corner.

3. Carefully grab the drive belt and put it

around the slot of motor pulley.

4. Connect the power adapter to the

turntable and power on the turntable. Set the speed to either 33 or

45. If the platter does not spin, try the steps listed above again.

5. Remember to place the rubber slip mat on the platter before

playing records.

Cartridge downforce adjustment

1. Gently push and turn the Counterweight onto the rear of the

tonearm (with the scale facing toward the front of the turntable).

2. Remove the cartridge protection cap.

3. Lower the tonearm lift and position the cartridge in the space

between tonearm rest and platter.

4. Carefully rotate the Counterweight until the tonearm balances

out. The tonearm should return to the balanced position if it is

moved up or down. This adjustment must be done carefully.

5. Once the tonearm is correctly balanced return it to its rest. Hold

the Counterweight without moving it, and gently rotate the Down

force Scale ring (the part with numbers on it) to 0. Check whether

the arm still balances out.

6. Rotate the counterweight counter clockwise (seen from the front)

to adjust the down force according to the cartridge manufacturer's

recommendations.

NOTE: The recommended downforce for the factory fitted cartridge

is 1.8 g.

Argon Audio A/S | DALI Allé 1, DK-9610 Nørager, Denmark

T T - 4 M a n u a l