Digitrax UT4D Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di controllo Digitrax UT4D. Digitrax UT4D 8. Duplex equipped radio utility throttle

Joining a Duplex Group For The First Time With UT4D:

1. Insert a known good 9 volt battery into the UT4D.

2. Plug the UT4D into a LocoNet port on a layout equipped with a UR92

transceiver to join that layout's Duplex Group.

3. After the UT4D has joined a Duplex Group, any time a battery is inserted

into the UT4D while it is unplugged, it will search for that Duplex Group.

The UT4D will join the Group if it is within range.

4. When the throttle has re-joined the Group, the Status light will blink Green

5 times. The UT4D then will attempt to select the Loco address on the 4

rotary address selectors.

5. If the UT4D's Status light blinks red 5 times this means that no UR92 with

the Group Name is within range. You may need to move closer to the

UR92 for the Duplex group to re-join the Group or you can simply plug in

to LocoNet to join another Duplex Group that is available.

Loco Selection: (Acquiring a locomotive address to operate on UT4D)

1. Dial up the desired 2 or 4 digit address using the 4 rotary address selectors.

Addresses from 0000 through 9983 are supported by UT4D.

(2-digit addresses are entered in the 2 right hand selectors, example 0025)

2. If a Duplex Group has been joined wirelessly, simply press the SEL key to

begin operating the loco address, otherwise plug the UT4D into a LocoNet

port and automatic selection of the address will occur.

3. The Status light will blink Green about once per second to confirm the

address selection.

4. If the Status light is blinking Red, this means the loco address shown on the

address selectors is not selected or is already selected by another throttle

(see Stealing below if you want to steal the loco from the other throttle).

If the selected loco is already moving, then the loco's speed will gradually

match the current speed setting of the UT4D. This means that if you've select-

ed a train that's moving forward at approach speed, and the UT4D throttle is

set to zero, when selection occurs, the train will slowly come to a stop.

Forward/Brake/Reverse Control Switch

Changing the Direction switch from 'Forward'(F) to the center 'Brake' position

causes the loco to stop at the loco's programmed deceleration rate. Changing

quickly from 'F' to 'R' causes the loco to stop at the programmed deceleration

rate, then reverse direction and accelerate at the loco's programmed

acceleration rate.

Release a Locomotive Address and Dispatch Address from UT4D:

When you are finished running a particular locomotive address, you can release

it from the UT4 by changing the position of the rotary address selectors. You

can also Dispatch the address so that it is specially identified as the just

released loco so that another user can take control of it.

igitrax

ommand

Run Your Trains, Not Your Track!

www.digitrax.com

ontrol