Digitrax UT1 Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Unità di controllo Digitrax UT1. Digitrax UT1 11. Traditional style loconet throttle

Stampa la pagina

UT1 Traditional Style Throttle Manual

Table of Contents (continued)

6.0 Troubleshooting

6.1 Clean Track

6.2 UT1 Won't power up when plugged in (LEDs Flicker)

6.3 Decoder Won't Respond

6.4 Emergency Stop

6.5 Mechanical Drive Train Problems

7.0 FCC Information

8.0 Warranty and Repair Information

Digitrax, LocoNet and others included in this manual are trademarks

of Digitrax, Inc

Digitrax, Inc. is not responsible for unintentional errors

or omissions in this document.

1.0 UT1 Utility Throttle Features and Specifications

The UT1 is a "traditional" hand held DCC throttle. The UT1 is laid

out with a single knob for speed control and a simple toggle switch

for direction.

Digitrax LocoNet network forms a simple, reliable interconnect

between all Digitrax Command Control System components using

extremely reliable and convenient gold plated RJ12 6 pin modular

telephone jacks.

Control up to 98 locomotives (97 DCC & 1 Analog)

128 speed step operation!

Simple locomotive selection using two rotary selectors.

Control directional lighting & 5 additional function outputs from the

keypad. If you have locomotive equipped with sound, controls for

bell & whistle are on F1 & F2. F2 is a non-latching control that

allows you to sound the horn for as long as the key is held down. F2

can be configured to be non-latching.

F3 can be configured to be momentary for remote coupler functions,

etc...

Special "DISPATCH" function to allow consists or 4 digit addresses

to be operated by the UT1.

"SAFE" mode operation allows smooth pick-up and or release of

trains or locomotives.

Your success with and enjoyment of our products are very important to

us. After all, this is a hobby and it is FUN!!! Please read this manu-

al carefully before you install your system. We have included lots of

hints and operating ideas based on our experience with the Digitrax

system. If you have questions not covered by this manual please

contact your dealer or Digitrax.

2.0 Using your UT1

For operation, the UT1 does not need a battery. The UT1 will remember

the last throttle settings after it is unplugged from LocoNet and will

resume when it is plugged back into LocoNet.

Plug the UT1 into any LocoNet jack on your LocoNet system

When the UT1 is first connected to LocoNet all the LEDs in its display

will blink on and then off again. This means that the throttle is

working and is communicating as it should.

2.1 Turning On Track Power

Turn on the track power by pressing and holding the "RUN/STOP" button, then

simultaneously pressing the "ON/F1" button. The command station will beep

once and the "TRACK STATUS" light on the command station will come on.