Cisco PIX 506 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Hardware di rete Cisco PIX 506. Cisco PIX 506 8. Chapter 3
Anche per Cisco PIX 506: Manuale di avvio rapido (18 pagine)

Stampa la pagina

Removing and Replacing the PIX 506/506E Chassis Cover

This section describes how to remove and replace the chassis cover from the PIX 506/506E. This section

includes the following topics:

•

Removing the Chassis Cover

Complete the following to remove the chassis cover:

Removing the chassis cover does not affect your Cisco warranty. Upgrading the PIX security appliance

Note

does not require any special tools and does not create any radio frequency leaks.

Read the Regulatory Compliance and Safety Information document.

Step 1

Power off the security appliance and unplug the power cord.

Step 2

Warning

Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.

Disconnect the network interface cables.

Step 3

Step 4

Remove the two screws from the back of the chassis (see

Figure 3-8

With the rear panel facing you, slide the chassis cover back and then lift it up off the bottom section, as

Step 5

shown in

Cisco PIX Security Appliance Hardware Installation Guide

3-6

Removing the Chassis Cover, page 3-6

Replacing the Chassis Cover, page 3-7

Removing PIX 506/506E Chassis Cover Screws

ACT

LINK

ACT

ETHE RNET 1

Figure

3-8.

POWE R

INPUT

LINK

ETHE RNET 0

USB

CON SOLE

Chapter 3

Figure

3-8).

PIX 506/506E

78-15170-02