Cisco SCE8000 10 GBE Manuale di avvio rapido - Pagina 7

Sfoglia online o scarica il pdf Manuale di avvio rapido per Hardware di rete Cisco SCE8000 10 GBE. Cisco SCE8000 10 GBE 25. 10 gbe power supply

Stampa la pagina
Before you connect system power or turn on the Cisco SCE 8000 chassis, you must complete this procedure:
Step 1
Remove approximately 0.75 inch (19 mm) of the covering from the end of the grounding wire using a wire-stripping
tool.
Insert the stripped end of the grounding wire into the open end of the grounding lug.
Step 2
To secure the grounding wire in place in the grounding lug, use the manufacturer recommended crimping tool.
Step 3
Step 4
Locate and remove the adhesive label from the system grounding pad on the chassis (Figure 4).
Figure 4
Installing the System Ground
FA N S
SCE 800 0-SC
TA TU S
M-E
SC M
1
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACT IVE
SCE 800 0-SC
M-E
2
SC M
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACT IVE
SCE 800 0-SI
P
3
SIP
4
TX
SC E8 00
TX
0- FA N
TX
A
RX
TX
C
CT RL
B
D
RX
RX
A
B
C
RX
D
ST AT US
OP TIC AL
BY PA SS
OP B- SC
1
Place the grounding wire lug against the grounding pad, making sure that solid metal-to-metal contact exists.
Step 5
Secure the grounding lug to the chassis using two M4 screws. Ensure that the grounding lug does not interfere with
Step 6
other hardware or rack equipment.
Step 7
To ensure adequate earth ground for the Cisco SCE8000 chassis, prepare the other end of the grounding wire, and
connect it to an appropriate grounding point at your site.

Connecting Power

The following sections describe how to reconnect the AC or DC power.

Installing a DC-Input Power Supply

The DC return must remain isolated from the system frame and chassis (DC-I).
Note
Warning
Before you perform any of the following procedures, ensure that power is removed from the DC circuit.
System ground
Grounding
connector
lug
STA TU S
OP TIC AL
BY PAS S
SCE 8000
STA TU S
OP TIC AL
BY PAS S
SCE 8000
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
E8 K- MM
Wire
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
System ground
connector
7