Cisco TelePresence ISDN Link Manuale dell'amministratore - Pagina 11

Sfoglia online o scarica il pdf Manuale dell'amministratore per Hardware di rete Cisco TelePresence ISDN Link. Cisco TelePresence ISDN Link 27. Isdn link

Stampa la pagina

Cisco TelePresence ISDN Link

Contents

Introduction

Upgrading the software

Before you start using the system, make sure that the ISDN Link has the latest software version

installed. Go to: http://www.cisco.com/go/isdnlink-docs, and select Download Software to check

which is the latest software version.

The ISDN Link can be upgraded from a command line interface.

Checking the software version

To check software version, run the command:

xStatus SystemUnit Software Version

D14954.01

ISDN Link Administrator Guide IL1.0, June 2012.

Getting started

Configuration examples

Downloading and installing the software

If you have Internet access; initiate a software upgrade by fetching the software on a given URL. If

the FTP site requires username and password, these parameters must be included.

Alternative method for software upgrading

If you do not have Internet access, follow the SCP upgrade method.

SCP Upgrade Method

Password protection

1. Software is available from the following URL:

http://ftp.tandberg.com/pub/software/endpoints

xCommand SystemUnit SoftwareUpgrade URL: "http://ftp.tandberg.com/pub/

software/endpoints/isdnlink/<filename>" UserName: "" Password: ""

*r SoftwareUpgradeResult (Status=OK)

2. When finished loading and installing the software, the unit will reboot.

1. Download the software to your computer. Software is available from the following URL:

http://ftp.tandberg.com/pub/software/endpoints

2. Root access needs to be enabled on ISDN Link (See

3. Copy the file to the ISDN Link using SCP, ensuring that the file is placed in folder /appl and is

named installsw:

i. If using SCP from the command line of your computer enter:

scp filetoupload.pkg [email protected]:/appl/installsw

ii. If using WinSCP then connect to the ISDN Link as root and copy the file into /appl folder.

IMPORTANT:

When you see the copy dialogue box showing /appl/*.* change this to /

appl/installsw so that the filename is changed to installsw. When file is copied using

WinSCP you may get some errors - these can be ignored.

4. Once the file has been uploaded to ISDN Link the unit needs to be restarted in order to use the

new software.

i. If logged in as root enter reboot.

ii. If logged in as admin enter xCommand Boot.

5. You can check the software version by logging in as admin. The software version is displayed

when logging on to the unit, or you can run the command xStatus SystemUnit and look for

the Software Version.

Administrator guide

Appendices

"Setting a root password"

on page 21)