Cisco TelePresence MCU MSE 8510 Come iniziare - Pagina 8

Sfoglia online o scarica il pdf Come iniziare per Hardware di rete Cisco TelePresence MCU MSE 8510. Cisco TelePresence MCU MSE 8510 16. Getting started

Stampa la pagina

Initial configuration

Step one: Configure Ethernet Port A settings

The default setting for the MCU MSE 8510 Ethernet ports is auto-sensing mode. If

the switch ports to which you connect the MCU MSE 8510 are not also set to auto-

sensing mode, then you need to configure the MCU MSE 8510 Ethernet ports to use

the same speed and duplex mode.

Both ends of the Ethernet connection must be configured in the same

way. For example, either configure both ends of the link to be auto-

sensing or configure both ends to operate at the same speed and duplex.

To establish a 1000Mbps connection, both ends of the link must be

configured as auto-sensing.

To configure Ethernet Port A, log in to the Supervisor's web interface and go to

Hardware > Blades

online help accessible from the Supervisor's web interface.

Step two: Assign an IP address to the MCU MSE 8510

You can use the Supervisor's web interface to configure the IP addresses of all blades

installed in the MSE 8000. Note that all blades are supplied with DHCP enabled. and

therefore the MCU MSE 8510 will attempt to find an IP address. The LCD panel will

show the IP address allocated. You can either keep this setting or assign static IP

addresses to a blade from the Supervisor's web interface. To view or configure the IP

address of the MCU MSE 8510, log in to the Supervisor and go to

. To access the web interface of the MCU MSE 8510, go to

Blades

and click the IP address of that blade.

Blades

. For more information about configuring the port, refer to the

Initial configuration

Hardware >