Cisco 2500 Series Manuale di configurazione - Pagina 11

Sfoglia online o scarica il pdf Manuale di configurazione per Server Cisco 2500 Series. Cisco 2500 Series 19. Wireless controller
Anche per Cisco 2500 Series: Manuale di installazione (12 pagine), Manuale d'uso (23 pagine), Manuale di configurazione (50 pagine), Manuale introduttivo (47 pagine)

Interface

Ethernet0

Serial0

Serial1

Choose what protocols to support on your Ethernet or Token Ring interface. For

Step 4

IP-only installations, you can accept the default values for most of the questions.

A typical configuration using IP, IPX, and AppleTalk follows:

Configuring global parameters:

Enter host name [Router]: router

Enter the enable secret password, the enable password, and the virtual terminal

Step 5

password:

The enable secret is a one-way cryptographic secret used

instead of the enable password when it exists.

Enter enable secret : shovel

The enable password is used when there is no enable secret

and when using older software and some boot images.

Enter enable password : trowel

Enter virtual terminal password: pail

Enter yes or no to accept or refuse SNMP management:

Configure SNMP Network Management? [no]:

The Simple Network Management Protocol (SNMP) is the most widely supported

open standard for network management. It provides a means to access and set

configuration and run-time parameters of routers and communication servers.

SNMP defines a set of functions that can be used to monitor and control network

elements.

Step 6

Determine if you will be using DECnet on your access server. If you are

configuring for DECnet, enter the appropriate values for your area number, node

number, and area routing:

Configure DECnet? [no]:

IP-Address

OK?

unassigned

Configuring the Cisco 2500 Series Access Server 4-11

Configuring the Access Server

Method

Status

not set

down

not set

down

Protocol

down