Cisco Firepower 2130 Come iniziare - Pagina 21
Sfoglia online o scarica il pdf Come iniziare per Server Cisco Firepower 2130. Cisco Firepower 2130 42. Rack-mount and ground the chassis
Anche per Cisco Firepower 2130: Manuale (12 pagine), Manuale d'uso (8 pagine), Installazione e manutenzione (26 pagine)
Getting Started
• Connect GigabitEthernet 1/3 to a redundant outside router, and GigabitEthernet 1/4 to a redundant inside
• Connect Management 1/1 to your management computer (or network).
(Optional) Change Management Network Settings at the CLI
If you cannot use the default management IP address, then you can connect to the console port and perform
initial setup at the CLI, including setting the Management IP address, gateway, and other basic networking
settings. You can only configure the Management interface settings; you cannot configure inside or outside
interfaces, which you can later configure in the GUI.
Note
Note
Procedure
Step 1
Connect to the FTD console port. See
information.
Step 2
Log in with the username admin.
The default admin password is Admin123. On AWS, the default admin password for the FTDv is the AWS
Instance ID, unless you define a default password with user data (Advanced Details > User Data) during the
initial deployment.
Step 3
The first time you log into the FTD, you are prompted to accept the End User License Agreement (EULA)
and to change the admin password. You are then presented with the CLI setup script.
Defaults or previously-entered values appear in brackets. To accept previously entered values, press Enter.
See the following guidelines:
These interfaces form a hardware bypass pair.
router.
These interfaces form a hardware bypass pair if your model has copper ports; fiber does not support
hardware bypass. These interfaces provide a redundant network path if the other pair fails. All 4 of these
data interfaces are on the same network of your choice. You will need to configure the BVI 1 IP address
to be on the same network as the inside and outside routers.
If you need to change the Management 1/1 IP address from the default, you must also cable your
management computer to the console port. See
CLI, on page
21.
You do not need to use this procedure for the Firepower 4100/9300, because you set the IP address manually
when you deployed.
You cannot repeat the CLI setup script unless you clear the configuration; for example, by reimaging. However,
all of these settings can be changed later at the CLI using configure network commands. See
Firewall Threat Defense Command
(Optional) Change Management Network Settings at the CLI
(Optional) Change Management Network Settings at the
Reference.
Logging Into the Command Line Interface (CLI), on page 9
Cisco Secure
for more
Getting Started
21