B2 Audio MA 1000.2 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore B2 Audio MA 1000.2. B2 Audio MA 1000.2 6.
Stampa la pagina
SPEAKERS CONNECTIONS
SPEAKERS CONNECTIONS
1000. 4 FOUR CHANNEL
CH1 SPEAKER
CH2 SPEAKER
2~4 Ohm
2~4 Ohm
CH1
CH2
FUSE
CH3
CH4
BRIDGED
CH3 SPEAKER
CH4 SPEAKER
2~4 Ohm
2~4 Ohm
BRIDGED MODE
SPEAKER
4~8 Ohm
CH1
CH2
FUSE
CH3
CH4
BRIDGED
SPEAKER
4~8 Ohm
- 8 -
+12V
REM
GND
+12V
REM
GND
POWER CONNECTION LEADS
BATTERY
HEAD UNIT
DC 12V
NOTES ON THE POWER SUPPLY:
Connect the +12V power input lead only after all other leads have been connected.
Be sure to connect the ground wire of the unit securely to a metal part of the car.
A lose connection may cause a malfunction of the amplifier.
REM: The unit is turned on by applying +12 Volts to this terminal. This terminal does
not draw heavy current like the tow Power Terminals so a thinner connecting wire is
acceptable. Standard 18 GAUGE is fine and the standard color is yellow. If the radio is
equipped with a Power Antenna control wire, it can drive this terminal. If the Power
Antenna wire is already in use, you can still splice into it. With this method, the unit will
turn on automatically with the radio.
Use the power supply lead with a fuse attached whose value is the same as original
fuse.
Place the fuse in the power supply lead as close as possible to the car battery.
During a full power operation, Maximum current will run through the system.
Therefore, make sure that the leads to be connected to the +12V and GND terminals
of the unit respectively must be larger than 8-Gauge (AWG.8).
- 9 -
To a metal part of car