Epson ES-300C Bollettino di assistenza prodotti - Pagina 7

Sfoglia online o scarica il pdf Bollettino di assistenza prodotti per Scanner Epson ES-300C. Epson ES-300C 14. Laser & non-impact printer error codes
Anche per Epson ES-300C: Bollettino di assistenza prodotti (19 pagine), Manuale (8 pagine), Manuale supplementare (15 pagine), Manuale (11 pagine), Bollettino di assistenza prodotti (20 pagine), Bollettino di assistenza prodotti (25 pagine), Bollettino di assistenza prodotti (13 pagine)

EPL-7000 cont.

You may have inserted a font card or cartridge while the printer was on line or

while the FEED light was on. Data still remains in the printer's buffer.

The optional lower paper cassette is not installed and the INPUT option is set

to OPT or AUTO.

[S] RESET

The printer is being reset to the previous settings in the macro specified with

LOAD MACRO option in SelecType Level 1.

[S] ROM Check

The printer is checking ROM.

If this message appears when you are trying to save a macro with the SAVE

MACRO option in SelecType Level 1, the printer does not have enough

memory to save any additional macros

A controller error has been detected.

A print engine error has been detected.

XX= 03 Fusing Unit (low temp)

[E] SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of

text and graphics.

[S] STANDBY MODE

When both CH P and CH S remain off for about thirty minutes, the printer

enters standby mode and this message appears.

[E] STARTUP ERROR

If this message appears when you turn on the printer, the power may have

been turned off while the printer was performing a save or reset operation.

04 Main Drive Motor

05 Ozone Fan motor

06 Polygon Mirror Drive

09 HSync Signal

PSB No: P-0077

Page: 6 of 11