Cisco UCS B200 M3 Manuale di installazione - Pagina 13

Sfoglia online o scarica il pdf Manuale di installazione per Server Cisco UCS B200 M3. Cisco UCS B200 M3 34. Blade server
Anche per Cisco UCS B200 M3: Nota di installazione e manutenzione (36 pagine), Nota di installazione e manutenzione (37 pagine), Manuale (8 pagine), Manuale di aggiornamento (21 pagine), Nota di installazione e manutenzione (28 pagine)

populating DIMMs in a blade server, and the rules depend on the blade server model. Refer to the documentation for a specific blade

server for those rules.

HDD status LEDs are on the front face of the HDD. Faults on the CPU, DIMMs, or adapter cards also cause the server health LED

to light solid amber for minor error conditions or blinking amber for critical error conditions.

Working Inside the Blade Server

Installing a Motherboard CMOS Battery

All Cisco UCS blade servers use a CR2032 battery (Cisco PID N20-MBLIBATT=) to preserve BIOS settings while the server is

powered down.

Warning

There is danger of explosion if the battery is replaced incorrectly. Replace the battery only with the same

or equivalent type recommended by the manufacturer. Dispose of used batteries according to the

manufacturer's instructions. Statement 1015

To install or replace a motherboard complementary metal-oxide semiconductor (CMOS) battery, follow these steps:

Procedure

Step 1

Remove the old CMOS battery:

a) Power off the blade, remove it from the chassis, and remove the top cover.

b) Push the battery socket retaining clip away from the battery.

c) Lift the battery from the socket. Use needle-nose pliers to grasp the battery if there is not enough clearance for your

fingers.

Step 2

Install a motherboard CMOS battery:

a) Push the battery socket retaining clip away from where the battery fits in the housing.

b) Insert the new battery into the socket with the battery's positive (+) marking facing away from the retaining clip. Ensure

that the retaining clip can click over the top of the battery to secure it in the housing.

c) Replace the top cover.