Cisco UCS B260 M4 Nota di installazione e manutenzione - Pagina 41
Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B260 M4. Cisco UCS B260 M4 50. Blade server
Anche per Cisco UCS B260 M4: Nota di installazione e manutenzione (46 pagine)
Stampa la pagina
Servicing the Blade Server
Procedure
Step 1
Position the VIC board connector above the motherboard connector and align the captive screw to the standoff
post on the motherboard.
Step 2
Firmly press the VIC board connector into the motherboard connector.
Step 3
Tighten the captive screw.
Tip
Figure 19: Installing a VIC mLOM Adapter
Installing an Adapter Card
All the supported mezzanine cards have a common installation process. These cards are updated frequently.
Currently supported cards and the available models for this server are listed in the specification sheets at this
URL:
http://www.cisco.com/c/en/us/products/servers-unified-computing/ucs-b-series-blade-servers/datasheet-listing.html
If you are switching from one type of adapter card to another, before you physically perform the switch make
sure that you download the latest device drivers and load them into the server's operating system. For more
information, see the firmware management chapter of one of the Cisco UCS Manager software configuration
guides.
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs
To remove a VIC, reverse the above procedure. You might find it helpful when removing the
connector from the motherboard to gently rock the board along the length of the connector until it
loosens.
Installing an Adapter Card
33