Cisco UCS E Series Manuale di installazione - Pagina 29
Sfoglia online o scarica il pdf Manuale di installazione per Server Cisco UCS E Series. Cisco UCS E Series 46. Ucs e series unified computing system
Anche per Cisco UCS E Series: Panoramica del prodotto (8 pagine), Manuale di risoluzione dei problemi (28 pagine)
Stampa la pagina
Command or Action
Step 3
Server# scope cimc
Step 4
Server/cimc# scope firmware
Step 5
Server/cimc/firmware# update tftp-ip-address
path-and-filename
Step 6
Server/cimc/firmware# show [detail]
Step 7
Server/cimc/firmware# activate [1 | 2]
Step 8
Click Ctrl a Ctrl q.
Step 9
Router# hw-module subslot slot/subslot
maintenance disable
Step 10
Router# hw-module subslot slot/subslot reload
Online Insertion and Removal
Online insertion and removal (OIR) provides uninterrupted network operation, maintains routing
information, and ensures session preservation on the Cisco 3900 series ISR G2 and Cisco ISR 4451-X.
You can use online insertion and removal to install or replace hardware without affecting system
operations.
The Cisco 2900 series ISR G2 does not support OIR of the E-Series Servers.
Note
To avoid damaging the router, turn off the electrical power on the router and disconnect network cables
before inserting or removing the E-Series Server from the Cisco 2900 ISR G2.
The OIR commands for the Cisco 3900 series ISR G2 and Cisco ISR 4451-X are different. See the
following topics for more information:
•
•
Removing the E-Series Server from a Cisco 3900 Series ISR G2
This section includes the following topics:
•
•
•
OL-26447-03
Removing the E-Series Server from a Cisco 3900 Series ISR G2, page 29
Removing the E-Series Server from a Cisco ISR 4451-X, page 31
Shutting Down the E-Series Server Installed in a Cisco 3900 Series ISR G2, page 30
Restarting the E-Series Server Installed in a Cisco 3900 Series ISR G2, page 30
Inserting the E-Series Server in a Cisco 3900 Series ISR G2, page 30
Purpose
From the CIMC CLI, enters the CIMC command mode.
Note
Enter the commands in Step 3 through Step 8 from
the E-Series Server.
Enters the CIMC firmware command mode.
Starts the CIMC firmware update. The server will obtain the
update firmware at the specified path and file-name from
the TFTP server at the specified IP address.
Displays the available firmware and status.
Activates the selected image. If no image number is
specified, the server activates the currently inactive image.
Exits the CIMC session.
Enables error recovery.
Enter the commands in Step 9 and Step 10 from the
Note
router.
Reloads the E-Series Server.
Note
This reload power-cycles the E-Series Server.
Hardware Installation Guide for Cisco UCS E-Series Servers
Online Insertion and Removal
29