Cisco 1100 Series Installazione e aggiornamento - Pagina 4
Sfoglia online o scarica il pdf Installazione e aggiornamento per Porta d'ingresso Cisco 1100 Series. Cisco 1100 Series 15. Terminal gateway
Anche per Cisco 1100 Series: Manuale (12 pagine), Manuale di installazione dell'hardware (44 pagine)
Stampa la pagina
Locating Internal and External Slots for Modules
1
Installing the Internal PoE Daughter Card
Use the following procedure to install an Internal PoE daughter card:
Step 1
Read the Safety Warnings and disconnect the power supply before you perform any module installation.
Step 2
Confirm the router is turned off and disconnected from the power supply.
Step 3
Open the chassis according to the instructions in the Removing the Chassis section.
Step 4
Locate the three metal standoff holes, and install the metal standoffs into the three holes. Make sure that the standoffs
are straight when installed. Tighten them gently but firmly, to a torque of 6-8 in-lbf.
Step 5
Place the PoE daughter card on top of the three metal standoffs, lining up the screw holes in the PoE daughter card with
the metal standoffs.
Step 6
Gently push the PoE daughter card down towards the system board until it is firmly fixed.
Step 7
Insert the three M3 (48-0530-01) screws provided, through the PoE daughter card and into the metal standoffs. Tighten
the screws using a torque of 5 in-lb.
Step 8
Close the chassis cover according to the instructions in the Replacing the Cover section, and connect the power supply
cable.
Figure 3: Internal PoE Daughter Card Assembly
1
3
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
4
Screws
Metal Standoffs
Installing and Upgrading Internal Modules and FRUs
PoE Module
2
PoE Daughter Card