Cisco Expressway CE1200 Manuale di installazione dell'apparecchio - Pagina 38
Sfoglia online o scarica il pdf Manuale di installazione dell'apparecchio per Porta d'ingresso Cisco Expressway CE1200. Cisco Expressway CE1200 42.
Anche per Cisco Expressway CE1200: Manuale di installazione (23 pagine)
Stampa la pagina
Task 2: IRP Reinstall Using the KVM Console
Step 2
Click the menu arrow in the top left corner and navigate to Storage > Cisco FlexFlash.
Step 3
Under the General tab, click Activate/Reset FlexFlash Controller and click ok in the popup window that appears. The
reset ensures your FlexFlash Controller is in the correct state.
Step 4
Click the Virtual Drives tab.
Step 5
Check the Hypervisor checkbox.
Step 6
Click Enable Virtual Drive and confirm that you would like to enable the virtual drive.
Task 2: IRP Reinstall Using the KVM Console
Step 1
Launch the KVM Console using the icon in the CIMC.
Step 2
Power up the CE1200 and, when prompted, press
Step 3
Select
Boot Options
Step 4
When prompted, press
Step 5
Select
CiscoVD Hypervisor
Step 6
When prompted, type
Step 7
Type
to reboot.
b
During this reboot we recommend disabling the virtual drive (although you can also do it later as described in Task 3
below). To disable the virtual drive now:
a. Press
to enter boot Setup.
F2
b. Under
Boot options
c. Press
F10
d. While the system reboots, return to the Virtual Drive info tab—in the CIMC interface under Storage—and check
the Hypervisor checkbox. Click Disable.
Step 8
After the reboot completes, connect using serial to complete the reset. You will see the factory installation wizard.
Step 9
You can optionally apply any option keys for the appliance (such as room or desktop registrations). If you choose not
to at this stage, they can be applied later through the Expressway web UI or CLI.
Step 10
When prompted, press
The factory installation wizard phase is complete.
Step 11
Power on the appliance, and follow the steps in
Task 3: Disable the Virtual Drive After the Reinstall
If you chose not to disable the virtual drive during the reinstall stage, we recommend that you do it now:
Step 1
Access the CIMC interface.
Step 2
Go to Storage > Virtual Drive infotab.
Cisco Expressway CE1200 Appliance Installation Guide (14.0)
32
and ensure that the
CiscoVD Hypervisor
to enter the
F6
Boot Menu
as the boot option.
and press
to proceed with the reinstall.
y
Enter
select
CiscoVD Hypervisor
to save and exit.
to shutdown the system.
Enter
to enter
.
F2
setup
is visible as one of the options.
.
and disable it.
Run the Install Wizard
to complete the customer installation wizard.
Troubleshooting