Cisco RF Gateway 10 Manuale di avvio rapido - Pagina 11

Sfoglia online o scarica il pdf Manuale di avvio rapido per Porta d'ingresso Cisco RF Gateway 10. Cisco RF Gateway 10 41. Cisco systems rf gateway quick start guide

Stampa la pagina

To install the rack-mount brackets for a mid-mounted configuration on a Cisco RFGW-10 UEQAM, complete the following

steps:

Step 1

Locate the threaded holes on the middle sides of the chassis that align with the holes in the rack-mount bracket. Ensure

that you hold the front rack-mount bracket with the ear and holes facing outward and towards the rear of the chassis

(see Figure 6).

Install all the six M5 undercut flat head screws (provided in the accessory kit) to secure each of the rack-mounting

Step 2

bracket to the chassis. Three screws are installed on each end of the rack-mounting bracket.

Step 3

Repeat Step 1 through Step 2 on the other side of the chassis.

Install the chassis in the rack. To install the Cisco RFGW-10 UEQAM in a rack, go to Installing the Cisco RFGW-10

Step 4

UEQAM in a Rack, page 11.

Figure 6

Attaching the Rack-Mount Brackets for Mid-Mount Configuration to the Cisco RFGW-10 Chassis

Cisco RFGW-10 Chassis

Rack-mount screws

Installing the Cisco RFGW-10 UEQAM in a Rack

After installing the rack-mount brackets, the installation handles on the chassis, and the installation brackets in the rack, mount

the chassis by securing the rack-mount brackets to the two posts or mounting strips in the rack. Because the rack-mount brackets

supports the weight of the entire chassis, be sure to use at least four rack-mount screws on each side to fasten the two

rack-mount brackets to the rack posts.

Rack-mount bracket