Cisco SM-X-8FXS/12FXO Manuale di installazione dell'hardware - Pagina 14
Sfoglia online o scarica il pdf Manuale di installazione dell'hardware per Porta d'ingresso Cisco SM-X-8FXS/12FXO. Cisco SM-X-8FXS/12FXO 40. Voice gateway
- 1. Table of Contents
- 2. Location and Mounting Requirements
- 3. Temperature Control and Ventilation
- 4. Rack Requirements
- 5. Access to Chassis
- 6. Power Source and Supply
- 7. Network Cabling Considerations
- 8. Interference Considerations
- 9. Required Tools and Equipment for Installation
- 10. Site Log
- 11. Installation Checklist
Temperature Control and Ventilation
Note
The Cisco VG400 Voice Gateway chassis is designed for back and sides-to-front airflow.
Temperature Control and Ventilation
The installation location (room, closet, or cabinet) for the Cisco VG400 Voice Gateway should always be
well ventilated and provide adequate air circulation to ensure proper cooling. The room temperature should
be maintained between 32 to 104°F (0 to 50°C).
Note
The Cisco VG400 Voice Gateway chassis is designed for back and sides-to-front airflow.
Rack requirements
The following information can help you plan your equipment rack configuration:
• Allow clearance around the rack for maintenance.
• Enclosed racks must have adequate ventilation. Ensure that the rack is not congested, because the hardware
• When mounting a chassis in an open rack, ensure that the rack frame does not block the intake or exhaust
If the Cisco VG400 Voice Gateway is installed in an enclosed rack with a ventilation fan at the top, make
sure that heated air drawn upward from other equipment does not prevent adequate cooling.
Note
Enclosed racks must have adequate ventilation. An enclosed rack should never be overcrowded and should
have louvers and a fan
If the chassis is installed using slide rails, check for blocked ventilation ports when it is in position in the rack
or cabinet. Make sure that the ventilation ports of the Cisco VG400 Voice Gateway are not blocked.
Baffles can help isolate exhaust air from intake air. Baffles also help draw cooling air through the cabinet.
The best location for the baffles depends on the airflow patterns in the rack. You can test the airflow by
experimenting with different equipment arrangements.
Access to Chassis
Allow space at the rear of the chassis for cable connections. Also consider the need to access the chassis for
future upgrades, maintenance, and troubleshooting.
Cisco VG400 Voice Gateway Hardware Installation Guide
12
generates heat. An enclosed rack should have louvered sides and a fan to provide cooling air. Heat
generated by equipment at the bottom of the rack can be drawn upward into the intake ports of the
equipment above it.
ports. If the chassis is installed on slides, check the position of the chassis when it is seated in the rack.
Planning Your Installation