Epson Stylus CX6000 Series Manuale - Pagina 14

Sfoglia online o scarica il pdf Manuale per Scanner Epson Stylus CX6000 Series. Epson Stylus CX6000 Series 19. Ink cartridge for use with stylus cx5000; cx6000; cx7400; cx8400; cx9400f; cx9475f printers;
Anche per Epson Stylus CX6000 Series: Iniziare qui Manuale (8 pagine), Aggiornamento (1 pagine), Manuale (4 pagine)

Stampa la pagina

Epson Stylus CX6000 Series

Cleaning the Print Head

If your printouts are unexpectedly light or faint, or you notice

light or dark bands across your printout, you may need to

clean the print head. This unclogs the nozzles so they can

deliver ink properly. Run a nozzle check (as described above)

to see if the print head needs cleaning.

Note:

Print head cleaning uses ink, so clean it only if quality declines and the

nozzle check indicates that the print head needs to be cleaned.

If the message on the photo viewer screen shows that a cartridge is

expended, you cannot clean the print head. In this case, replace the

appropriate ink cartridge first (see the next section).

1. Make sure the CX6000 Series is on but not printing.

2. Press the

Setup/Utilities

3. Press the

button to select

print head

4. Press the x

button to start cleaning. The CX6000

Start

Series runs a head cleaning cycle and the

Caution:

Never turn off the CX6000 Series while head cleaning is in

progress. You may damage it.

5. When the

light stops flashing, run a nozzle check

(as described in the previous section) to verify that the print

head is clean.

6. If there are still gaps or lines, or the test patterns are faint,

run another cleaning cycle and check the nozzles again.

Note:

If you don't see any improvement after cleaning the print head

three times, turn off the CX6000 Series and wait overnight. This

lets any dried ink soften. Then try cleaning the print head again. If

quality still does not improve, one of the ink cartridges may be

old or damaged and needs to be replaced (see the next section).

Tip:

If you do not use your CX6000 Series often, it is a good idea

to print a few pages at least once a month to maintain good

print quality.

button.

Press Start to clean the

light flashes.

Replacing Ink Cartridges

Checking the Ink Cartridge Status

When an ink cartridge is low, the icon shown below is

displayed on the photo viewer screen:

Low ink

icon

When printing or copying, a bar showing which ink cartridge

is low is displayed next to the low ink icon:

Low ink

icon and

bar

When an ink cartridge is expended, the following photo

viewer screen is displayed:

Expended

cartridge

To check ink cartridge status anytime, follow these steps:

1. Press the

Setup/Utilities

2. Press the l or r button to select

levels

3. Press the x

Start

photo viewer screen displays your

approximate ink levels.

Note:

If a cartridge is more than six months

old, print quality may decline. If

necessary, try cleaning the print head

(see the previous section). If printouts

still do not look their best, you may need to replace the cartridge.

Caution:

Leave the expended cartridge installed until you have obtained a

replacement, or the ink remaining in the print head nozzles may

dry out.

6/06

button.

Press Start to check ink

button. The