TomTom LINK 530 Manuale di installazione - Pagina 33

Sfoglia online o scarica il pdf Manuale di installazione per Sistema di navigazione per auto TomTom LINK 530. TomTom LINK 530 40.

Wiring digital inputs

The digital inputs of the LINK 530 operate according to the principle of a voltage detector. Voltag-

es below 2 Volts are definitively interpreted as being low and voltages higher than 3 Volts are

definitively interpreted as being high. The maximum permissible input voltage is 30 Volts.

Low/high switching (increasing input voltage) typically occurs at 2.8 Volts. High/low switching

(decreasing input voltage) typically occurs at 2.1 Volts. The hysteresis of 0.7 Volts is to avoid rapid

switching.

Interference voltages at the digital inputs must remain below 2 Volts. In order to guarantee this,

the input wire of the connecting cable should never remain unconnected. If a digital input is not

being used, the input wire must be connected to ground (GND). To evaluate a switch, this switch

needs to be designed as a change-over switch, switching the digital input between plus and minus

(ground GND) of the vehicle electrical system voltage (+9 ... 30V).

If no change-over switch is available, an electric load for example, indicator light or resistor,

between the digital input and ground (GND) or between the digital input and the vehicle voltage

(+9 ... 30V) can offer defined levels.

When using inductive loads, a free-wheeling diode must be used in parallel with the load.