Crow EDS-2000AM Manuale di istruzioni per l'installazione - Pagina 16

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Accessories Crow EDS-2000AM. Crow EDS-2000AM 18. Outdoor pir + mw detector
Anche per Crow EDS-2000AM: Manuale di istruzioni per l'installazione (18 pagine), Istruzioni per l'installazione e manuale d'uso (20 pagine)

At this time the detector is ready for operation.

11. Self-test

Self test is meant to ensure that the detector functionalities (PIR & MW) are working properly.

Self-test occurs on initial warm-up and every 10h afterwards.

Following the self-test, if any technical failure is obtained, the yellow LED will flash constantly

– this means that the detector is out-of-order.

12. Test procedures

Walk Test

Make sure LEDs control is set to "ON"

Allow 30 seconds of warm up time.

Make sure that the protected area is cleared of all people.

Start walking across the detection zone.

Look at the LEDs whenever motion is detected - all LEDs are turned ON.

Allow 5 sec. between each test for the detector to stabilize.

Upon installation, the unit should be thoroughly tested to verify proper operation.

Walk across the entire area where coverage is desired. Should the coverage be incomplete,

readjust sensitivity or relocate the detector.

Once coverage is as desired the LEDs may be disabled.

NOTE: Walk Test procedure should be conducted, at least once a year, to confirm

proper operation and coverage of the detector.