Epson Stylus Color 900 Manuale informativo sul prodotto - Pagina 6

Sfoglia online o scarica il pdf Manuale informativo sul prodotto per Accessori per stampanti Epson Stylus Color 900. Epson Stylus Color 900 13. For windows and macintosh
Anche per Epson Stylus Color 900: Specifiche tecniche (2 pagine), Iniziare qui Manuale (12 pagine), Bollettino di assistenza prodotti (6 pagine), Bollettino di assistenza prodotti (1 pagine), Scheda informativa sul prodotto (4 pagine), Bollettino di assistenza prodotti (3 pagine), Bollettino di assistenza prodotti (2 pagine), Bollettino di assistenza prodotti (4 pagine), Bollettino di assistenza prodotti (7 pagine), Manuale d'uso (40 pagine), Manuale online (12 pagine)

Stampa la pagina

EPSON Stylus COLOR 900

6. Place the black ink cartridge in its holder with the label

facing up and toward the back of the printer. Then press

down the clamp until it locks into place.

7. Press the R cleaning button to move the color ink cartridge

holder into the installation position.

If the print head doesn't move to the color ink cartridge

installation position, hold down the cleaning button for

three seconds until the print head moves to the color ink

cartridge installation position.

8. Repeat steps 5 and 6 to install the color ink cartridge.

9. Press the R cleaning button to begin charging the ink

delivery system and then close the printer cover.

Charging takes about two minutes. The P power light flashes,

and the printer makes various sounds until it is finished.

Don't turn off the printer or interrupt the charging process or

it will start over and you'll use more ink than necessary.

Charging is complete when the P power light stops flashing

and is stays on.

Never turn off the printer when the P power light is

flashing, unless the printer hasn't moved or made any

noise for more than five minutes.

6 - EPSON Stylus COLOR 900

Testing the Printer

You can run a printer check to determine whether the

problem comes from the printer itself or some other source.

Follow these steps to run the printer check:

1. Make sure both the printer and computer are turned off.

2. Disconnect the interface cable from the printer.

3. Make sure paper is loaded in the printer.

Load paper that's at least 8.27 inches (210 mm) wide.

This prevents ink from spraying inside the printer and

smudging your printouts.

4. Hold down the E load/eject button, then press and release

the Ppower button. Continue holding down the E load/

eject button until the Ppower light starts to flash, then

release it.

The printer prints one page showing its ROM version

number, ink counter, and a nozzle check pattern in black,

magenta, cyan, and yellow. Only the nozzle check pattern is

shown below.

5. To end the check, turn off the printer after it prints the

check page. Then reconnect the interface cable and turn on

your printer and computer.

If the results are satisfactory, the problem lies in your

software settings, the interface cable, or your computer.

If the check page does not print correctly, you may have

a problem with your printer. First try cleaning the print

head (see page 10). Then try the suggestions in

"Problems and Solutions" in the Printer Basics book or

"Troubleshooting" in the EPSON Stylus COLOR 900

Manual.

1/99