Motorola DEFY Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Telefono cellulare Motorola DEFY. Motorola DEFY 16. 34.4.9 upgrade for motorola defy
Anche per Motorola DEFY: Aggiornamento software (2 pagine), Istruzioni per l'aggiornamento del software (3 pagine)

FCC Regulation

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference re-

ceived, including interference that may cause undesired operation.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC note:

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

RF Exposure information (SAR)

This device is designed and manufactured not to exceed the emission limits for exposure to radio fre-

quency (RF) energy set by the Federal Communications Commission of the United States.

During SAR testing, this device was set to transmit at its highest certified power level in all tested fre-

quency bands, and placed in positions that simulate RF exposure near the body with the separation of

5 mm. Although the SAR is determined at the highest certified power level, the actual SAR level of the

device while operating can be well below the maximum value. This is because the device is designed to

operate at multiple power levels so as to use only the power required to reach the network.

The exposure standard for wireless devices employing a unit of measurement is known as the Specific

Absorption Rate, or SAR.

The SAR limit set by the FCC is 1.6 W/kg.

This device is complied with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-

1992 and had been tested in accordance with the measurement methods and procedures specified in

IEEE1528. The FCC has granted an Equipment Authorization for this device with all reported SAR levels

evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on

file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after

searching on FCC ID: ZL5BM3A01.

The highest reported SAR values under the FCC regulatory for the device are listed below:

Body SAR: 1.42 W/kg

While there may be differences between the SAR levels of various device and at various positions, they

all meet the government requirements.

SAR compliance for body-worn operation is based on a separation distance of 5 mm between the unit

motorola defy satellite link