Motorola CLP107e Manuale d'uso - Pagina 33

Sfoglia online o scarica il pdf Manuale d'uso per Radio bidirezionale Motorola CLP107e. Motorola CLP107e 42.

Figure 13: Cloning the Radio through a Multi-Unit Charger

5.4

Troubleshooting Cloning Mode

When and where to use:

The radio audible voice announces "Bonk" indicating that the cloning process has failed. In the event

that cloning fails, perform each of the following steps before attempting to start cloning process again.

Procedure:

1 Ensure that the batteries on both radios are fully charged and engaged properly on the radio.

2 Check the cloning cable connection on both Single-Unit Chargers (SUC).

3 Ensure that there is no debris in the charging tray or on the radio contacts and the radio contact

is touching the SUC or MUC contact firmly.

4 Ensure that the Target Radio is turned on.

5 Ensure that the Source Radio is in cloning mode.

6 Ensure that the two radios are both from the same frequency band, same region and have the

same transmission power.

NOTICE: This cloning cable is designed to operate only with compatible Motorola

Solutions SUC.

When ordering cloning cable kit, refer to part number HKKN4028_. For more information about the

accessories, see

Accessories on page

42.

MN007419A01-AA

Chapter 5: Radio Cloning