Epson Equity 386SX PLUS Bollettino di assistenza prodotti - Pagina 7

Sfoglia online o scarica il pdf Bollettino di assistenza prodotti per Desktop Epson Equity 386SX PLUS. Epson Equity 386SX PLUS 26. Product support bulletin(s)
Anche per Epson Equity 386SX PLUS: Bollettino di assistenza prodotti (19 pagine), Manuale informativo sul prodotto (10 pagine), Manuale informativo sul prodotto (10 pagine), Bollettino di assistenza prodotti (45 pagine)

ITEMS INCLUDED

Equity 386SX PLUS CPU with 1MB (soldered), power cord.

101 key enhanced keyboard (6-pin mini DIN).

User's manual, slip-sheet and warranty card.

One key, used for locking the top cover of the CPU.

Three drive cables:

Read/write floppy cable.

Read-only floppy cable, identified by heat shrink tubing located near the

connector that connects to the main board.

IDE Hard drive cable with connectors for two drives.

Setup is only available on boot-up (RESET or warm boot), and only when in

'Administrator" mode (jumper J1 is set to "B"). When the computer completes

its power-on diagnostics, two beeps will occur (this is not a SETUP error) and

the following prompt will appear:

After 5 to 8 seconds if F10 is not pressed, the computer will continue to boot.

If F10 is pressed, the Setup screen will appear. Press the F7 key twice to save

and reboot. Refer to page 3 of this document for a listing of the setup options.

If in "User" mode (J1 set to "A"), one beep will occur, no F10 option will

appear, and the system will continue booting.

Differences in Setup between the standard Equity 386SX PLUS and the

diskless version include

Extended memory size can be specified (in 128K increments).

Diskette boot control. Choose "Disabled" to use the system as a

dedicated workstation network node. Choose "Enabled" if a diskette

drive is installed and you want to be able to boot the system from that

drive.

After Setup is run you may want to change jumper J1 to position A and lock

the computer cover with the key lock. This changes the operating mode to

user mode and protects the computer's configuration.

Press F10 to run Setup

the

following:

PSB No: S-0133

Page: 2 of 4