Motorola TALKABOUT T92 Manuale - Pagina 33

Sfoglia online o scarica il pdf Manuale per Radio bidirezionale Motorola TALKABOUT T92. Motorola TALKABOUT T92 35. Portable two-way radios

Stampa la pagina

To start Basic Scanning:

1. Press the

key briefly. The Scan

the display and the radio will begin to scroll through the

channel and code combinations.

2. When the radio detects channel activities matching the

channel and code combination, the radio will stop scrolling

and you can hear the transmission.

3. Press the PTT button within 5 minutes after the end of the

transmission to respond and talk to the person transmitting.

4. The radio will resume scrolling through the channels 5

seconds after the end of any received activity.

5. Press the

Scan/Monitor button briefly to stop scanning.

To start Advanced Scanning:

To set another channel and start Dual Channel Monitor:

1. Press the

Scan/Monitor button briefly. The Scan

icon will appear in the display and the radio will begin to

scroll through the channels. No Interference Eliminator

Codes will filter what is heard.

2. When the radio detects channel activities with ANY code (or

NO code), it stops scrolling and you can hear the

transmission. Any Interference Eliminator Code that may be

use by other party will be detected and displayed.

3. When you respond and talk to the person transmitting, press

the PTT button within five seconds after the end of the

transmission.

4. The radio will resume scrolling through the channels 5

seconds after the end of any received activity.

5. Press the

Scan/Monitor button briefly to stop scanning.

Scanning Notes:

1. The transmission will be on the "Home Channel" if you press

icon will appear in

the PTT button while the radio is scrolling through inactive

channels. You may press the

stop scanning at any time.

2. You may immediately resume the scan by briefly pressing

the

transmission.

3. You may temporarily remove that channel from the scan list

by pressing and holding

stops repeatedly on an undesired transmission. You may

remove more than one channel this way.

4. Turn the radio OFF and then turn back ON, or EXIT and re-

enter the scanning mode by pressing

button to restore and remove channel(s) to the scan list.

5. You cannot remove the "Home Channel" from the scan list.

6. In the Advanced Scan, the detected code will only be used

for one transmission. You must take note of that code, exit

scan and set the detected code on that channel to

permanently use the detected code.

Water Sensor

When the radio comes in contact with water, the WHITE LED

will begin flashing until the battery is dead. Press the Flashlight

button to turn off the flashing LED.

Scan/Monitor button to

if the radio stops on an undesired

for 3 seconds if the radio

Scan/Monitor